Catler SB 4010 User Manual

Page 13

OPERATING YOUR CONTROL GRIP SB 4010

4. Place the lid onto the chopping bowl so

that the grooves on the chopping blade
fi t into the openings on the bottom part
of the lid.

5. Allign the upper part of the lid with the

correspondant openings on the motor
unit and push down until the motor unit
clicks into its place. Ensure the motor unit
is properly and fi rmly placed on the lid.

Always place the chopping blade on the pivot
pin on the buttom of the chopper bowl before
placing any food in the bowl. Do not lift the
blade before the complete chopping operation
is fi nished.

NOTE

Using the chopper
Ensure the chopper is completely and
properly assembled as stated in the previous
part of the manual.
1. Insert the plug into a 230/240V~ power

outlet.

2. Select a speed between 1 – 15 to process

the food.

3. Press and hold the main switch to start

the chopping. The main switch must
be held for the required duration of
operation. If you release the main switch,
the appliance will stop.

4. Once the food is suffi

ciently chopped,

release the main swich, wait until the
blade stops and unplug the power cord
plug from the power outlet.

5. Detach the motor unit (see the next

chapter) and the lid. Carefully remove
the chopping blade and use a spatula
to scrape off any food residues from the
blade. Use a spatula to remove food from
the chopping bowl.

Disassembling the chopper
1. Before disassembling the device ensure

the main swich has been released, the
rotary blade has stopped and the power
cord plug has been removed from the
power outlet.

THE CHOPPING BLADE IS VERY SHARP. PAY YOUR OWN ATTENTION WHEN
HANDLING THE BLENDING ATTACHMENT.