Catler SB 4010 User Manual

Page 11

OPERATING YOUR CONTROL GRIP SB 4010

Using the stick mixer
Ensure the blending attachment is attached
correctly to motor unit as stated in the
previous part of the manual.
1. Place food to be processed into the

blending jug (or suffi

cient mixing bowl

or saucepan). The jug provided should be
only ½ full or less when blending liquids
or when making fruit / vegetable puree.

2. Insert the plug into a 230/240 V~ power

outlet to power on.

3. Rotating speed of blade can be operated

by speed control dial which is located at
the top of motor unit.

Low speed: 1

High speed: 15

Processing food, it is recommended that you
start with a low speed and gradually increase
to the higher speed to avoid splattering and
over-processing.

NOTE

4. Place the stick mixer as deeply as possible

into the jug and press the main switch.
The main switch must be held for the
required duration of operation. If you
release the main switch, the appliance will
stop.

5. Work through the ingredients in the jug

with a gentle raising and lowering motion.

6. If you need to stop the appliance, release

the main switch.

7. Ensure the motor has completely stopped

before lifting the stick mixer out of the
jug.

8. When processing has fi nished, switch

off at the power outlet and remove the
power plug.

Disassembling the stick mixer
1. Before disassembling the device ensure

the main swich has been released, the
rotary blade has stopped and the power
cord plug has been removed from the
power outlet.

2. Place the device on the fl at surface and

hold the blending attachment with one
hand. Using thumb and fi nger of the
other hand, press on the eject buttons on
either sides of the motor body. Press both
buttons and pull the motor unit upwards.

BLENDING BLADE IS VERY SHARP. PAY YOUR OWN ATTENTION WHEN
HANDLING THE BLENDING ATTACHMENT.