CASO Germany MyVac 20 - Manual (Page 52)

caso Vakuumierer MyVac 20 52
Please note
► The airproof loop of sponge should be dried thoroughly prior
to reassembling.
► When re-assembling, be careful to prevent any damage and
assembles as original position to ensure no vacuum leaking.
17 Troubleshooting
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical
equipment.
► Improperly performed repairs can cause considerable
dangers for the user and damages to the device.
17.2 Cause and Action
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
Failures Possible Cause Resolution
The vacuum sealer
does not function
The device hasn’t been used
for a longer period and the
battery is weak
► Recharging
The accessories are only
loosely put on
► Check all parts are put on
firmly
The charging device
does not charge
Defective socket
► Look for a proper socket
The charging device and the
charging station are not
connected correctly
► Check the connection
The device does not
work after charging The charging time was too
short
► Fully charge the device as
described under Recharging
The vacuum produced
► Close the zip catch once again