Salter Brecknell RD-65 Remote Display - Manual (Page 15)

13
4.2 Installation of suspending way
4.2.1 Install the remote display through a suspender or suspended wire
1) Put a suspender into the rings or put a burly wire through the rings to hang the remote
display; and be careful not to drop the Remote Display.
2) Loosen the locknut, adjust the display window angle and fasten the locknut, and be
careful: don¡t let the lock nut be removed fully during the installation
Fig.10
4.2.2 Install the remote display onto the wall
1) Push two expansion bolts into the wall
2) Screw self tapping screws into expansion bolts and keep 5mm to 8mm out of the wall.
3) Loosen the locknut, move away two hanging-rings, hang the remote display onto self
tapping screws; adjust the display window angle and fasten the locknut.
4) Be careful: don’t let the lock nut be removed fully during the installation
Suspender
Remote Display
Lock nut
Hanging-rings