Salter Brecknell SBI100 - Manual (Page 31)

SBI 100 User Instructions Manual 29
7 Error Codes
Error Message Definition Required Solution/Troubleshooting
0¯ ¯ ¯ ¯: Weight above range for calibrated
zero point. Remove load before zeroing Or Recalibrate the scale.
0_____: Weight below range for calibrated
zero point. Remove load before zeroing Or Recalibrate the scale.
_____: Indicates an under range condition Remove all loads and zero the scale.
¯ ¯ ¯ ¯: Capacity exceeded Remove the load and try again. If the load is great than 6 kg a scale
with a larger capacity is required.
CAL-Er: Calibration error Restart calibration
Lo.bAt: Low Battery Recharge the battery. Upon initial use, it is recommended to charge
battery for 8 hours prior to use.
EEP.E0 EEPROM can't be accessed Replace S100 Indicator
EEP.E1 Configuration settings have changed
and not been stored Calibrate the scale to store settings
EEP.E2 P7-P9 settings exceed scale's normal
range Reconfigure P7-P9 setting