Salter Brecknell 3700LP - Manual (Page 16)

16 3700LP Bench Scale Series User’s Manual
For both styles of brackets, follow these steps to install the mounting bracket
and attach the display:
1. Disconnect the power and display cables and turn the scale upside
down.
2. Place a cable twisty (supplied on original display assembly) thru the two
holes on the vertical side of the display bracket so that the ends point
toward the back of the sloped display mounting surface. Twist once to
hold in place until ready to secure the excess display cable. (See
Figures 5 and 6 for mounting drawings.)
3. Place the display mounting bracket on the scale base, aligning the holes
in the bracket with the proper holes in the baseplate.
4. Secure the bracket to the baseplate with the two 10-32 screws provided
(100-250 lb bases) or the feet (10-50 lb bases).
5. Pull the protective paper from the back of the two magnetic strips. Apply
one to the center of the mounting bracket and the other to the center of
the back of the display.
6. Reconnect the display cable. Route the cable towards the front of the
scale away from the channel and loop in the cable clips located in
appropriate places underneath the scale base.
7. With minimal slack in the cable, secure the remaining excess cable
within the v-shaped valley of the bracket and secure with the tie wrap.
Be sure that there is sufficient cable available to allow the display to
attach to the front of the bracket with the magnetic strips.
8. Inspect the display cable and twisty to insure there is no interference
with the live weighing portion of the scale.
9. Return the scale to normal operating position.
10. Position the display housing on the bracket so the two magnetic strips
connect. See Figure7.
Figure 7
Mounting the display
11. Reconnect power to the scale and check for proper operation.
Be sure there is no interference
with the movement of the
weighing platform.
Installation