AVer EH1116H-4 Nano user manual - Manual (Page 69)

63
number in second for the program to continue recording after the alarm has ended. The time range is
1~999 seconds. If user doesn
’t mark and set the time, the alarm recording will continue recording until
alarm is reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point setting.
Beside the PTZ preset point check box, click Detail. In the
Trigger PTZ Preset Setting dialog box, select the PTZ camera
number then select the Enable check box. Select the position
of the PTZ camera when the alarm is activated and ended. For
the PTZ camera end point, user can also select on preset
position or Auto Pan between preset position groups.
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video
to CMS when the alarm is activated.
Beside the Send to CMS check box, click Detail. In
the CMS Setting, select the camera to
enable/disable sending the video to CMS. Enable
All to select all cameras. Then, click OK to accept
the new settings and Cancel to exit without saving.