AVer EH1116H-4 Nano user manual User Manual
Page 100
94
- Relay Output
Set to enable/disable the relay operation when the alarm is activated
and to extend additional time in second before it stops the relay
operation.
1. Next to the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available relay list
and in the ON column, set to enable/disable the relay operation
when the alarm is activated.
3. In the Retrieve time check box, you may enable/disable to extend
the relay operation time and set the duration in second.
4. Click OK to exit and accept the setting and Cancel to exit without
saving the setting.
- Send E-mail
Send an electronic text message. Beside the Send Email check box, click Detail.
In the E-mail Setting dialog box, click OK to exit and save the setting and Cancel to exit without saving the
setting.
Mail Server
Enter the SMTP Server and port. If your e-mail
system requires user identification, enable
Authentication check box and enter ID and
Password.
Fill the mailing information.
From: Enter the sender e-mail address.
To and CC: Enter the recipient email
address and separate it with comma or a
semicolon (;).
Subject: Enter the message title.
Message: Type the message.
-
Start Recording
Record the video from the selected camera.
1. Next to the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select the
camera to enable/disable video recording. Enable All
to select all cameras.
3. In the Frame Rate selection, select As Setting to
record the number of frames based on the Recording
Setting.
4. In the Start Record prior text box, mark and set the
number in second for the program to begin recording
after the alarm has been trigger. The time range is
1~10 seconds.
5. In the Stop Record after text box, mark and set the
number in second for the program to continue