Arc Machines 205 WDR User Manual

Page 18

M O D E L 2 0 5

O P E R A T O R ’ S M A N U A L

5. Insert the two coolant line quick-disconnect fittings on the adapter cable into the

mating WATER OUT

and WATER RETURN

connectors on the Model 205-

CW. These connectors are interchangeable so either connector may be connected
to either mating fitting. To prevent accidental disconnection after making the
connection, finger-tighten the lock screw on the male connectors.

6. Attach the weldhead control male connector on the adapter cable to the

WELDHEAD CONTROL connector

on the Model 205. Note the positioning

keyway and NEVER FORCE or use tools on the cable connectors. Hand-tighten the
connecting ring being careful not to cross-thread the ring.

7. Insert the male gas quick-disconnect fitting on the adapter cable to the mating ARC

GAS OUTPUT connector

on the Model 205 and hand-tighten the lock screw to

prevent accidental disconnection. Slide the rubber boot over the connection.

Fig. 1

Hookups for Non-Liquid Cooled Weldheads