Canon 130U - Manual (Page 36)

IVoubleshooting
In case of problems, check the table below before
taking your camera to be repaired.
Problem Solution
E3 blinks on the
LCD panel.
• Replace the battery. (^10)
ISi is not
displayed on the
LCD panel.
* Load the battery. (^10)
• Reload the battery
correctly. (^10)
■ Replace the battery. (->10)
The lens is not set ♦ Reload the battery
correctly (^10)
“0” blinks on the
frame counter ♦ Reload the film correctly
(-^11)
The shutter does
not release.
• Turn the power on. (->13)
• Replace the battery, (^10)
• Reload the film correctly.
(^11)
■ Remove the film and load a
new one (^11, 12)
■ Hold the shutter button
down until the shutter
releases. (->15)
- Change the flash mode.
(^22)
The photographs
are blurred. • Ensure that the AF sensor
is not obscured by your
hair, fingers etc (^19)
• Make sure that you do not
stand directly in front of the
camera when pressing the
shutter button. (^21)
• Press the shutter button
slowly and gently. (-^15)
• Wipe the AF sensor clean
(->6)
1-36