Flash shooting with built-in ttl flash – Nikon N4004s User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Flash shooting with built-in TTL flash

1. Push flash lock release

buttons to release built-in flash.

Lightly press shutter release
button to turn on the N4004s.

Check to make sure subject is
within proper flash shooting range

for film speed in use. If subject is
beyond flash shooting range,

ready-light LED blinks for approx.

3 sec. after releasing the shutter.

For details, see page 40.

Wait a few seconds for ready-

light to come on, then shoot.

Fully depress shutter release button

to take picture. This automatically
advances film by one frame.

> Upon shutter release, the expo

sure indicator LED(s) turns off
approx. 2 sec. after you remove
your finger from the button.

• If camera defects abnormality

during film advance (when film

is loaded), the self-timer indi
cator LED lights up for a few
seconds. If this happens, set
the shutter speed dial to L
Oock), then proceed as usual.