Preparation for use, Installing the battery – Nikon EL2 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARATION FOR USE_______
Installing the Battery
The exposure measurement and shutter control circuits
of the EL2 are powered by a single 6-volt (type 544)
battery mounted in the battery chamber at the bottom
of the mirror box. To install the battery, first remove
the lens (if mounted) from the camera body (see page
42) and lock up the mirror (turn the lockup lever
upward as far as it will go, as described on page 39) to
gain access to the battery chamber. Then, open the
battery chamber (slide the lid to the left, then up)
and install the battery, making sure to properly align
the positive (+) and negative (-) terminals of the
battery as depicted on the interior of the lid. After