Engine preparation, Pump preparation, Storage – Craftsman 919.762500 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Carburetor
The carburetor of your high pressure washer is pre-set
at the factory. The carburetor should not be tampered
with. )f you pressure washer is used at an altitude in
excess of 5000 feet consuit with your nearest Sears
Service Center regarding high altitude set changes.
A CAUTION: Engine speed was properly adjusted
at the factory and should require no additional
adjustment. Do not attempt to change engine
speed. If you believe the engine is running too fast
or too slow, take your pressure washer to a Sears
Authorized Service Center for repair and adjustment.
A
WARNING:
High engine speeds are dangerous and
increase the risk of persona! injury or damage to
equipment.
AWARNING:
Low engine speeds impose a heavy
ioad on the engine and when sufficient engine
power is not avaiiabie could shorten engine life.
Nozzle Maintenance
Hi-Low Lance:
1. Shut off the pressure washer and turn off the water
supply.
2. Disconnect spark plug wire.
3. Puil trigger on gun handle to relieve any water
pressure.
4. Disconnect the wand/iance from the gun.
5. Remove the high-pressure nozzle from the lance.
Remove any obstructions with the nozzle cleaning
tool provided and backflush with clean water.
6. Direct water supply into nozzle end to backflush
loosened particles for 30 seconds.
7. Reassemble the nozzle to the lance using teflon tape
to prevent leaks. Tighten securely.
8. Reconnect wand/iance to gun and turn on water
supply.
9. Start pressure washer and place wand/iance into
high pressure setting to test.
STORAGE
This pressure V\/asher should be stored in such a way to
protect it from freezing. Do not store this unit outdoors
or in an area where temperatures will fall below 32'^ R
This can cause extensive damage to this unit.
if unit has to be stored under freezing conditions a погь
toxic R.V. anti-freeze can be used to proteci from
freezing.
Preparing Pressure Washer for
Storage
NOTE:
If you do not plan
ur unit for 3C davs o:
more, unit should be prepared for storage.
Engine Preparation
• First add a fuel stabuizer to the fuel tanK.
• Run pressure washer for full 5 minutes to allow fuel
stabilizer to enter the fuel system.
NOTE:
While doing this procedure make sure water
supply is turned on and fiovrlng to the unit.
NEVER
run
unit without water supply running through pump,
® Next shut off engine and disconnect the water supply.
• Disconnect the spark plug wire and rem.ove the spark
plug.
» Add one teaspoon of oil through the spark plug hole.
• Place rag over spark plug hole and pull the recoil a
few times to lubricate the combustion chamber,
® Replace the spark plug, but do not connect the spark
plug wire.
Pump Preparation
* Be sure engine switch is in “OFF” position and spark
plug wire has been removed from spark plug.
® Pull the trigger on the spay gun to release the
pressure in the high pressure hose. Detach high
pressure hose and garden hose from the unit.
® Pull the recoil on the engine 4 to 6 times to discharge
remaining water in pump.
♦ Tip the unit on the end with the water inlet fitting
pointing upward.
« Pour approximately 1/4 cup of non-toxic R.V. anti
freeze down the fitting where the water hose attaches
to the pump.
• Set unit upright and pull starter handle on engine 4 to
6 times to circulate anti-freeze in pump until anti
freeze is discharged from the pump.
1 5