Craftsman 919.762500 - Manual (Page 11)

When engine starts, gradually move choke lever to
RUN position.
if engine does not start after 5 pu!is, piace choke
back to run position.
For hoi engine starts make sure c!ioke/run iever is in
the run position. Make sore fuel shut off valve is open
and throttle is in the Rabitt position,
NOTE: If any leaks are present shut unit down and
tighten fittings.
Prepare the soap/chemicai as required by your job.
insert soap/chemical line into your container (soap/
chemicals not included).
n=-
Û
How To Use Your Pressure Washer
On the end of your spray gun is a nozzle that you can
twist from side to side. With the adjustable nozzle you
can adjust the nozzle to either high pressure or low
pressure.
• Turn the nozzle in a counter clockwise direction to
achieve low pressure. Turn nozzle clockwise for high
pressure.
* For most effective cleaning, keep spray nozzle
between 8 and 24 inches of cleaning surface.
IMPORTANT: if you get spray nozzle too close,
especially on high pressure, you may damage the
cleaning surface.
• The pressure control knob is located on the pump.
You can increase the pressure by turning the knob
clockwise or decrease the pressure by turning the
knob counterclockwise.
PRESSURE
CONTROL™
KNOB
Ж
о \ \ \
NOTE; The maximum pressure for the unit is set at its
maximum setting at the factory. Do not attempt to adjust
the pressure higher than this factory setting.
Using Soaps/Chemicals
IMPORTANT: Use soaps and chemicals that are designed
specifically for use with pressure washers. To apply soap/
chemicals follow these steps:
NOTE: The first step involves applying an appropriate
soap/chemical solution to penetrate and loosen grime.
The soap/chemicai is applied at low pressure to avoid
splashing, over spray and waste. Leave the solution
on surface for 3 to 5 minutes to allow solution to work.
NOTE: The second step involves cleaning the surface
you have prepared with the pressure washer and then
rinsing it clean.
• Turn the adjustable nozzle counter clockwise to low
pressure mode. Soap/chemicals cannot be applied
with nozzle in high pressure position.
• Review the use of the adjustable nc-m
® Connect garden hose to water inlet fc" c "To Start Your
Pressure Washer"), check that high у ■ nose is
G о n n ect ed iо s p ray g u n a П d p 1 ЛТ 1 p fs -■ ■■ ,4 s e n ? о iy),
and start engine.
• Apply soap/chemicals to dry surface, eiarting from the
bottom and working up.
« Allow the SGap/chemi-ca;5 lo soak ..■■-епЗ-б
minutes before washing and nnsnp
* For cleaning, start at iovrer portio-: r
washed and work upward, using hv-
lapping strokes.
Your pressure washer is equipped vwi;
injector adjustment knob, 'with the -c-i
you will get maximum chemical draw
Closed you will gel no ci-crrvcai orar.r
counter clockwise direction to achieve
draw and clockwise for less chemice'
en oeer-
iiernicai
riy ope^ied
’ icb fuiiy
knor in
e cnoniioal
After using the pressure washer, it is recommended
the pump, chemical injector and chemical line be
flushed with clear water. To do so, simply place
chemical injector hose in water and siphon for 1 to 2
minutes.
11