Troubleshootin, Troubleshooting – Craftsman 486.24717 User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TROUBLESHOOTIN
PROBLEM
POSSIBLE CAUSE(S)
CORRECTIVE ACTION
Engine fails to start
1. Spark plug wire disconnected.
2. Safety switch not contacted.
3. Fuel tank empty, or stale fuel.
4. Fuel shut-off valve closed
(if so equipped).
5. Faulty spark plug.
1. Connect wire to spark plug.
2. Correctly install hose adapter nozzle.
3. Fill tank with clean, fresh fuel.
4. Open fuel shut-off valve.
5. Clean, adjust gap or replace.
Loss of power;
operation erratic.
1. Spark plug wire loose
2. Unit running on CHOKE.
3. Blocked fuel line or stale fuel.
4. Water or dirt in fuel system.
5. Carburetor out of adjustment.
6. Dirty air cleaner.
1. Connect and tighten spark plug wire.
2. Move choke lever to OFF position.
3. Clean fuel line; fill tank with clean
fresh gasoline.
4. Disconnect fuel line at carburetor to drain
fuel tank. Refill with fresh fuel.
5. Adjust carburetor.*
6. Service air cleaner.*
Engine overheats
1. Carburetor not adjusted
properly.
2. Engine oil level low.
1. Adjust carburetor.*
2. Fill crankcase with proper oil.
Too much vibration
Loose parts or damaged
impeller.
Stop engine immediately and disconnect
spark plug wire. Tighten all bolts and nuts.
Make all necessary repairs. If vibration
continues, have unit serviced by an
authorized service dealer.
Unit does not
discharge
1. Discharge chute (elbow)
clogged.
2. Foreign object lodged in
impeller.
3. Chip-N-Vac cart is full.
1. Stop engine immediately and disconnect
spark plug wire. Clean inside of housing
and discharge chute (elbow).
2. Stop engine immediately and disconnect
spark plug wire. Remove lodged object.
3. Empty cart.
Rate of discharge
when chipping
slows considerably,
or composition of
discharged material
changes.
Chipper blades dull.
Sharpen or replace chipper blades.
‘Refer to the engine manual packed with your unit.
NOTE: For repairs beyond the minor adjustments listed above, please contact your nearest authorized service dealer.
20
Call 1 -866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE