Craftsman 486.24717 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assemble the hose adapter (nozzle) to the front of
the Impeller housing and secure with the three knobs.
Make sure that the switch actuator bracket contacts
the switch on the housing. See figure 18.
Place a hose clamp onto one end of hose. Push hose
onto hose adapter (nozzle). Tighten hose clamp onto
hose and hose adapter. Do not collapse hose adapter
when tightening clamp. See figure 19
Place the hose hanger rod Into the hose hanger bracket
on the Impeller housing assembly. See figure 19.
Loop the 25" tarp strap under the hose. Hook to the
hose hanger rod. See figure 19.
HINT: Tip the cart bed back for easier access In the next
paragraph.
*. Attach the chipper chute assembly to the weld bolts
on the back side of the Impeller housing using three
5/16" flat washers and 5/16" Nylock nuts. Tighten.
See figure 20.
• Insert the tamper plug Into the end of the chipper
chute assembly.
Assemble the hitch plate to the tractor hitch If:
a. Your tractor has a square (straight) hitch frame,
to help prevent binding.
b. Your tractor has a lightweight hitch frame that
needs reinforcing for towing the Chip-N-Vac.
Use a 1/2" x 1-1/4" hex bolt, a 7/16" flat washer and a
1/2" nylock nut. See figure 21.
Call 1 -866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
13