beautypg.com

Craftsman 486.24717 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Position the adapter over the deck opening, and check

for fit of cutout as shown in figure 24. Trim cutout, if

necessary, to aiiow tiiting of adapter, keeping the fit as

cióse as possible for best vacuum suction.

• Assemble the adapter bracket to the deck using two

5/16"

X

1-1/4" hex bolts, 5/16" flat washers and 5/16"

nylock nuts. See figure 26.

NOTE: It may be necessary to use extra 5/16" flat

washers to shim under the bracket next to the deck
surface. Ten extra washers have been furnished as
shims. See figure 26.

Holding the adapter bracket and the deck adapter

together, position the deck adapter on the mower
deck. Keeping the edge of deck adapter as close as
possible to the offset in the adapter bracket, see if the
slot in the adapter bracket can be aligned with one
or two of the deflector holes in your mower deck's
discharge opening. If the bracket can not be located
correctly using existing holes, it will be necessary to
drill one or two 5/16" diameter holes in the deck. See
figure 25.

Use existing holes or drill 5/16"

diameter hole or holes.

as possible to offset in bracket

FIGURE 25

With deck adapter positioned correctly over the
discharge opening, use the adapter bracket as a
template and drill three 9/32" diameter holes in the top
of the deck adapter. See figure 27.

Bolt deck adapter to bracket using three 1/4" x 3/4"
bolts, nylon washers, 1/4" fiat washers and 1/4" lock
nuts. Nylon washers should be against the inside of

the deck adapter. See figure 27.

FIGURE 27

Assemble end of hose and a hose clamp over the

round opening of deck adapter and tighten clamp. GO
DIRECTLY TO THE OPERATION INSTRUCTIONS
ON PAGE 16.

Call 1 -866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE

15