beautypg.com

Craftsman 486.24717 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Assemble a short tarp strap to rear door using one

1/4"

X

1-1/4" hex bolt, two 1/4" flat washers and one

1/4" nylock nut. Assemble an "S" hook through loose

end of strap. See figure 15. Repeat on other side of
door.
Assemble door to rear of cart by resting bottom of
door on door supports and pushing top of door in
against cross brace. Secure top of door using door
latches on each side. See figure 15.
Hook both the tarp straps onto the 1/4" x 1" hex bolts
in the sides of the cart. See figure 15.

DOOR LATCH

1/4"

X

1-1/4" HEX BOLT

H

1/4" FLAT WASHER

,^^4^TARP STRAP (SHORT)

1/4" NYLOCK NUT

FIGURE 15

DOOR
SUPPORTS

1/4"

X

1"

HEX BOLT

Attach the engine/impeller housing assembly to the

upper holes in the angles welded to the tongue. Use

four 5/16"

X

3/4" hex bolts and 5/16" nylock nuts.

Tighten. See figure 16.

Assemble the elbow to the impeller housing using four
5/16"

X

3/4" thread forming hex bolts and four nylon

washers. Push while turning to help start the bolts into
the unthreaded holes. Tighten. See figure 17.
To center the elbow with the opening in the hard top:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/4 turn each, the four

bolts that you assembled in figure 17.

c. Push against the elbow to center it with the sides

of the opening.

d. Retighten the four bolts that you loosened.

Pull the vinyl boot onto the end of the elbow.

12

Call 1 -866-576-8388 for missing parts or assembly help

DO NOT RETURN TO STORE