Craftsman 486.24717 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Flip the cart over so that it rests on its wheels.
ASSEMBLING VAC PARTS
• Assemble the front tongue on top of the rear tongue
using three 3/8" x 3" hex bolts and 3/8" nylock nuts.
See figure 8.
HINT: For easier assembly, support the rear tongue with
a block of wood.
•
Assemble the hitch bracket to the front tongue using
two 3/8"
X
1-1/4" hex bolts and 3/8" nylock nuts.
Tighten. See figure 9.
•
Secure the hitch pin to the hitch bracket and tongue
with the hair cotter pin. See figure 9.
Release the latch lock lever and tilt the cart bed back.
See figure 10.
Assemble the front panel to the cart bed, sliding
the bottom lip of the panel in between the cart bed
and the latch stand bracket. Fasten the panel to the
bottom and sides of the cart bed using six 1/4" x 5/8"
hex bolts and 1/4" nylock nuts. Tighten. See figure 10.
Tighten the two bolts that you assembled to the latch
stand bracket in figure 5.
FIGURE 10
10
Call 1 -866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE