Craftsman 917.28948 - Manual (Page 27)

TO LEVEL MOWER
Make sure tires are properly inflated to the
PSI shown on tires. If tires are over or under
inflated, it may affect the appearance of your
lawn and lead you to think the mower is not
adjusted properly.
VISUAL SIDE-TO-SIDE ADJUSTMENT
1
. With all tires properly inflated and if your
lawn appears unevenly cut, determine
which side of mower is cutting lower,
NOTE: As desired, you can raise the low
side of mower or lower the high side.
2. Go to side of mower you wish to adjust,
3. With a 3/4" or adjustable wrench, turn
lift link adjustment nut (A) to the left to
lower the mower, or, to the right to raise
the mower.
Turn nut right
to raise mower Turn nut left
to lower mower
0294S
NOTE: Each full turn of adjustment nut will
change mower height about 3/16".
4. Test your adjustment by mowing some
uncut grass and visually checking the
appearance. Readjust, if necessary, until
you are satisfied with the results.
PRECISION SIDE-TO-SIDE ADJUSTMENT
1
. With all tires properly inflated, park tractor
on level ground or driveway.
A CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
2. Raise mower to its highest position.
3. At both sides of mower, position blade at
side and measure the distance (A) from
bottom edge of blade to the ground. The
distance should be thesame on both sides.
4. If adjustment is necessary, see steps 2
and 3 in Visual Adjustment instructions
above,
5. Recheck measurements, adjust if neces­
sary until both sides are equal,
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-
to-side.
To obtain the best cutting results, the mower
blades should be adjusted so the front tip is
1
/
8
" to
1
/
2
" lower than the rear tip when the
mower is in its highest position.
A
CAUTION: Blades are sharp. Protect
your hands with gloves and/or wrap blade
with heavy cloth.
• Raise mower to highest position,
" Position any blade so the tip is pointing
straightforward. Measure distance (B) to
the ground at front and rear tip of the blade.
If front tip of blade is not 1/8" to
1
/
2
" lower
than the rear tip, go to the front of tractor.
With an 11/16" or adjustable wrench,
loosen jam nut A several turns to clear
adjustment nut B.
With a 3/4" or adjustable wrench, turn
front link adjustment nut (B) clockwise
(Itighten) to raise the front of mower, or,
counterclockwise (loosen) to iower the
front mower.
NOTE: Each full turn of the adjustment nut
will change mower height about
1
/
8
".
Recheck measurements, adjust if neces­
sary until front tip of blade is
1
/
8
" to
1
/
2
"
lower than the rear tip.
Hold adjustment nut i n position with wrench
and tighten jam nut securely against ad­
justment nut.