Craftsman 917.28948 - Manual (Page 15)

^ FQ1!BÌGHTtSBH11}| :
THAHUaSOHr i
The operation of any tractor can resuit in foreign objects thrown into the
eyes, which can resuit in severe eye damage. Aiways wear safety glasses
or eye shields while operating your tractor or performing any adjustments
or repairs. We recommend standard safety glasses or a wide vision safety
mask worn over spectacles.
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine is
running, any attempt by the operator to leave
the seatwithout first setting the parking brake
will shut off the engine.
1, Depress brake pedal (B) all the way down
and hold,
2
. Pull parking brake lever (C) up and hold,
release pressure from brake pedal (B),
then release parking brake lever. Pedal
should remain in brake position. Make
sure parking brake will hold tractor secure.
STOPPING
MOWER BLADES -
• To stop mower blades, move attachment
clutch clutch lever to disengaged position
(ip).
8lii
(Ip) Attachment
Clutch Switch
"Engaged"
(rp)Attachment
Clutch Switch
“Disengaged”
ENGINE -
“ Move throttle control (D) between half and
full speed (fast) position.
NOTE: Failure to move throttle control be­
tween half and full speed (fast) position, be­
fore stopping, may cause engine to "backfire".
• Turn ignition key (F) to “STOP” position
and remove key. Always remove key when
leaving tractorto prevent unauthorized use,
■ Never use choke (N) to stop engine.
IMPORTANT: Leaving the ignition switch in
any position other than "STOP" will cause
the battery to discharge and go dead.
NOTE: Under certain conditions when tr;actor
is standing idle with the engine running, hot
engine exhaust gases may cause “brown­
ing” of grass. To eliminate this possibility,
always stop engine when stopping tractor
on grass areas,
A c AUTION: Aiways stop tractor com­
pletely, as described above, before leaving
the operator's position.
TO USE THROTTLE CONTROL (D)
Always operate engine at full speed (fast).
• Operating engine at less than full speed
(fast) reduces engine's operating efficiency.
• Full speed (fast) offers the best mower
performance.
GROUND DRIVE -
• To stop ground drive, depress brake pedal
all the way down.
IMPORTANT: Forward and reverse drive
pedals return to neutral position when not
depressed.
TO USE CHOKE CONTROL (N)
Use choke control whenever you are starting
a cold engine. Do not use to start a warm
engine.
• To engage choke control, puli knob out.
Slowly push knob in to disengage.
15