Assembly – Craftsman 536.772301 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY
HOW TO RAISE THE HANDLE
1. Loosen the
knobs
and raise the upper
handle to the upright position. See
Figure 2. Allow the
control rod
to swing
freely.
2.
Tighten the
knobs.
Make sure the
knobs
are to the outside of the handles
as shown in Figure
2.
3. Insert the end of the
control rod
from
left to right through the hole in the
quill
support arm.
Attach with
hair pin
found
in parts bag. See Figure 3.
4. When the clutch lever is in NEUTRAL
position, the
quill support arm
must be
close to the
screw
as shown in Figure 4.
* \ Control Rod
I \
Figure 2
F-001102M
See also other documents in the category Craftsman Tools:
- 247.795950 (24 pages)
- 247.797853 (24 pages)
- 315.111450 (12 pages)
- 152.22018 (19 pages)
- 137.21241 (31 pages)
- 572.61096 (59 pages)
- 572.6112 (23 pages)
- 1450 Series Engine (56 pages)
- G8693 (30 pages)
- 247.287751 (27 pages)
- 315.111920 (16 pages)
- 572.610720 (12 pages)
- 247.799891 (21 pages)
- 486.24219 (8 pages)
- 113.213832 (20 pages)
- 987.799601 (44 pages)
- 973.111490 (16 pages)
- 149.236321 (16 pages)
- 973.111330 (16 pages)
- 486.24515 (32 pages)
- 875.19119 (10 pages)
- 316.79246 (20 pages)
- 247.776360 (40 pages)
- 973.111471 (16 pages)
- 247.796890 (20 pages)
- 247.775870 (25 pages)
- 486.243152 (8 pages)
- 486.2454 (8 pages)
- 919.150020 (10 pages)
- 247.77636 (40 pages)
- 320.17217 (20 pages)
- 486.24516 (32 pages)
- 973.111291 (16 pages)
- 973.2748.70 (16 pages)
- 315.111640 (12 pages)
- 486.24326 (12 pages)
- 315.11516 (4 pages)
- C944.511573 (10 pages)
- 486.243361 (8 pages)
- 486.24218 (12 pages)
- 315.115510 (18 pages)
- 247.795940 (36 pages)
- 486.24336 (8 pages)
- 172.26729 (13 pages)
- 247.795861 (16 pages)