Operation – Craftsman 536.772301 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

OPERATION

HOW TO USE THE CURB-HOPPING FEATURE

wheel

until the

front wheel

is level with

the left rear wheel and the unit is setting

Because the front wheel and the right rear

wheel are adjustable, the Edger can be used

on uneven surfaces, such as the curb shown
in Figure 12. Set the wheel positions as fol
lows.

1. Stop the engine.

2. Disconnect the spark plug wire from the

spark plug.

3. Loosen the

front wheel knob.

Slide the

front wheel

to the best posi

tion to clear the curb and balance the

unit.

5. Securely tighten the

front wheel knob.

6. Use the

curb height adjust lever

lower the

front wheel.

Lower the

front

on the curb as shown in Figure 12.

Loosen the

rear wheel knob.

8. Lower the

right rear wheel

until the

Edger is level and the left rear wheel is

on the curb.

9. Securely tighten the

rear wheel knob.

10. Connect the spark plug wire to the spark

plug.

WARNING: Keep away from the

rotating blade. The blade can
cause injury.