Rx rv, Service and adjustment – Craftsman 536.772301 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

HOW TO REMOVE THE BELT
The belt made of a special compound. !f the
SERVICE AND ADJUSTMENT
belt becomes worn or breaks, replace the
belt with an original equipment belt.
1. Disconnect the spark plug wire from the
spark plug.
2. Pull the clutch lever back to release the
tension from the belt.
3. Remove the two
screws
and
spacers
from the top of the
engine pulley cover.
Remove the
engine pulley cover
(see
Figure 18),
4.
Loosen, do not remove, the
screw
that
holds the
belt guide.
Then, move the
belt guide
away from the
belt.
5. Remove the two
screws
from the
belt
guard
(see Figure 19).
6. Remove the old
belt
from the engine
and quill assembly pulleys. Replace with
an original equipment belt.
7. To install a new belt, reverse the above
steps.
© @
^
Spacer
1
Spacer
rX rV
Engine
' Pulley
. 'r
f
^
f
Belt
. Screw
Engine
Pulley
Cover
F-001102M
19