Assembly – Craftsman 139.53625SR User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly
DO NOT REMOVE CHAIN AND CABLE FROM CAFTTON,
Delach cable from side of carton and fasten to trolley with
a master fink from coin envelope,
MASTER LINK PROCEDURE: Push pins of master link
bar through loop of cable and hole in front end of trolley
(A) as shown. Push cap over pins and onto notches. Slide
clip-on spring over cap and onto pin notches until both pins
are locked in place.
Caation: fCeop the chain taut while instaiUng to help
prevent kinking.
With trolley against the screwdriver, dispense cable around
pulley. Proceed back around opener sprocket p)- be sure
sprocket teeth engage chain- and forward to the threaded
trolley shaft (C).
B
Opetw Chassis
Sprocket
insali Chain
(n This Direction
Use second master link to connect the chain to the flat
end of shaft as shown. Check to make sure chain Is not
twisted.
REMOVE SCREWDRIVER.
Master Unk
Ciip-On sprine
Master Unk
Clip-On Spring
Flat End
instali Chain and Cabie
In This Direction
Sprocket
Cover
Tab Skit
Mountins
Psaio
ATTACH SPROCKET COVER TO CHASSIS: insert back
IM
j
in chassis slot. Then bend cover forward and insert
front tab in slot provided on mounting plate-