Craftsman 315.228110 - Manual (Page 9)

UNPACKING
Your new table saw has been designed to give you
many years of high quality performance. To insure
this goal< proper care and treatment is important.
Careful treatment begins with removing all parts from
the carton and checking them against the list of loose
parts.
Your table saw is shipped complete in one carton and
includes a teg stand, two table extensions, a rip fence,
a miter fence with adjusting clamp, a blade guard, rails
and hardware.
■ Separate the saw and all parts from the packing
materials and check each against the packing list,
especially the small parts that can be hidden in the
packing material.
Note: Do not discard the packing materials until you
have carefully inspected the saw, identified all
parts, and satisfactorily operated your new saw.
If you are missing a part, check the packaging before
contacting Sears.
If any parts are missing, do not attempt to assemble
your table saw, plug in the power cord, or turn the switch
on until the missing parts are obtained and are installed
correctly. Complete parts lists are located at the end of
this manual. Use these lists to identify the part number
of any missing part. Contact your Sears Service Center
or Retail store and get the missing part(s) before
assembling and trying to use your saw.
WARNING: Never use gasoline, naptha, or
other highly volatile solvents. Do not ever let
brake fluids, gasoline, petroleum-based
products, or penetrating oils contact plastic parts.
Such chemicals can weaken or destroy plastic.
A WARNING: To prevent accidental starting that
could cause possible serious personal injury,
assemble all parts to your saw before connecting
it to power supply. Saw should never be
connected to power supply when you are
assembling parts, making adjustments, installing
or removing blades, or when not in use.
WARNING: If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
ACCESSORIES
The following recommended accessories are currently available at Sears Retail Stores.
^ WARNING: To avoid risk of injury, use
recommended dado and zero clearance throat
plate when employing a dado accessory.
Item No. 9-22210 Router Mounting Kit
Item No. 9-22211 Miter Slot Table
Item No. 9-22212 Zero Clearance Throat Plate
Item No. 9-22213 Dado Throat Plate
Item No. 9-22214 Micro-Position Rip-Fence Accessory
Item No. 9-22215 Quick Fold Table
Item No. 9-22216 Wide Table Kit DO NOT USE 7 in. WOBBLE DADOES
Item No. 9-22217 Long Miter/Rip Fence
Item No. 9-22218
Air Floatation Table ^ complete assortment of blades for your saw are
Item No, 9-22219 Wide Table Leg Set available at your nearest Sears Retail Store.
Item No. 9-22220 Miter Clamp Kit
WARNING: The use of attachments or accessories not listed might be hazardous.
CRHFTIMIIN* TABLE SAW 315.228110