Locker bracket assembly, Tilt / elevating mechanism, Lubrication – Craftsman 315.228110 User Manual

Page 42

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

LUBRICATION

This saw has been lubricated at the factory prior to

shipment. Following extended use, you should inspect
and lubricate the following areas to assure smooth

operation.

LOCKER BRACKET ASSEMBLY
See Figure 61.

■ Add dry lube between both bevel gears, the

backup washers and the locker bracket.

■ Add dry tube between threaded hole in motor

casting and threaded elevating shaft.

Recommended Lubricants;

Dry Silicone or Teflon Lubricant

TILT / ELEVATING MECHANISM

See Figure 62.

■ Add dry lube between the handle shaft and the

bore of the clamping bolt.

■ Add dry lube between the face of the clamping bolt

and the face of the handle shaft,

■ Add dry lube on the inner surfaces of the bevel

locking lever which contacts the cam.

CRHFTSHIIN' TABLE SAW 315.228110