To adjust quick-stop, To adjust quick stop – Craftsman 315.228110 User Manual

Page 41

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SLIDING MITER TABLE ASSEMBLY

Checks and Adjustments

TO ADJUST QUICK-STOP

The quick-stop is preset at the factory to stop the

miter fence at exactly zero degrees. However, when

sliding miter table adjustments are made, these

adjustments may cause the quick stop to need

adjusting. Check quick-stop with miter scale set at

zero degrees. If adjustments are needed, proceed
with the following steps:

■ Loosen the eccentric screw holding the quick-stop.

■ Place the quick-stop against the miter fence with

miter scale set at zero degrees.

See Figure 60.

■ Adjust eccentric screw until it holds quick-stop

securely against miter fence.

■ Retighten hex nut, securing eccentric screw and

quick-stop.

■ Check your work. If the quick-stop is not at zero

degrees, repeat steps 1-4.

MITER INDICATOR

ECCENTRIC SCREW

Figure 60

CRAFTSHAN' TABLE SAW 315.228110