Craftsman 580.761800 - Manual (Page 5)

• Cut the tie wraps on the high pressure hose and
connect high pressure hose to gun. Tighten by
hand.
Place assembled spray gun on holder.
Remove plastic cap and connect high pressure
hose to pump. Tighten by hand.
Attach nozzle extension to spray gun.
CHECKLIST
Before you operate your new high pressure washer
please review the following checklist:
• All assembly instructions have been completed.
• The high pressure hose connections to the spray
gun and to the pump are tight and secure.
While learning how to use your high pressure
washer, pay extra attention to the following important
items:
• Engine oil is at proper level
Important: Any attempt to crank or start the engine
before it has been properly serviced with the recom­
mended oil may result in an engine failure. See Page
8 for instructions on adding oil and proper oil specifi­
cations.
Important: The water supply to your pressure wash­
er must be connected and turned on prior to starting
your engine.
• Be sure gas tank is filled properly with clean,
fresh, unleaded gasoline.
• Become familiar with all controls - their location
and function. Operate those controls before start­
ing the engine.