Craftsman 580.761800 - Manual (Page 4)

ASSEMBLY
The following parts are shipped loose with your pressure
washer
• Main Unit — pressure washer with wheels,
guide handle.
• High Pressure Hose
• Manual Bag (which includes the items listed below)
• Ofliper’s Manual
• Nozzle Cleaner Kit
• Parts Box (which includes items listed below)
• Spray Gun
• Wand Extension with Hi/Lo Adjustable Nozzle.
• Wire Form
• Motor Oil
• “0"-RingKit
Become familiar with each piece before assembling the
pressure washer. Check all contents against the illustra­
tion on Page 6. If any parts are missing or damaged, call
the Pressure Washer Helpline at 1-800-222-3136.
TO REMOVE PRESSURE WASHER FROM
CARTON
• Remove loose parts and parts box included with pres­
sure washer. The high pressure hose is packed in the
bottom of the carton on the guide handle end.
Remove the hose.
• Slice two comers at guide handle end of carton from
top to bottom so the panel can be folded down flat,
then remove all packing material.
• Raise guide handle, secure in place and roll the pres­
sure washer out the open end of the carton.
Loosen knobs
to leise handle
\\\^
CARTON CONTENTS
For the most part, your Craftsman High Pressure Washer
has been assembled at the factory. You must, however,
attach the wire form, assemble the spray gun, and attach
the high pressure hose to the pump and spray gua
• While facing the rear of the Pressure Washer, insert
the wire sup^rt with the longer arm positioned on the
left. From this view the hook should resemble a “J".
HOW TO SET UP YOUR PRESSURE WASHER
Cut tie wrap on chemical Ejection tube. Rernove chemi­
cal irqectkxi filter, thread chemical rr^ecfion titoe through
the wire form and reinsert fitter mto tube.
Tighten knobs
when handle is
straight.
Check carton for additional loose parts.