Customer responsibilities, General recommendations, Maintenance – Craftsman 580.761800 User Manual
Page 10: Product specifications
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAINTENANCE
CUSTOMER RESPONSIBILITIES
MAINTENANCE SCHEDULE
RLL IN DATES AS YOU COMPLETE
HOURLY OPERATING INTERVAL
SERVICE DATES
REGULAR SERVICE
MAINTENANCE TASK
Before Each
Use
Every 25
Hours or
Yearly
Every
too
Hours or
Yearly
PRESSURE WASHER
Check/clean water inlet screen
on quick-connect.
xt
Check high pressure hose.
X
Check detergent hose.
X
Check spray gun and assembly for leaks.
X
Purge pump of air and contaminants.
X
ENGINE
Check oil level.
X
Change engine oil.
X*
Service air cleaner.
X"
Clean/replace spark plug.
X
Prepare for storage.
Prepare unit for storage if it is to
remain idle for longer than 30 days.
t Clean if clogged. Replace if perforated or tom.
* Change sooner when operating under heavy load or high ambient temperature.
" Clean more often under dirty or dusty conditions.
GENERAL RECOMMENDATIONS
The warranty of the high pressure washer does not cover
items that have been subjected to operator abuse or neg
ligence. To receive full value from the warranty, operator
must maintain high pressure washer as instructed in this
manual.
Some adjustments will need to be made periodically to
properly maintain your high pressure washer.
All adjustments in the Service and Adjustments section of
this manual should be made at least once each season.
• Once a year you should clean or replace the spark
plug and clean or replace the air filter and check the
gun and wand assembly for wear. A new spark plug
and clean air filter assure proper fuel-air mixture and
help your engine run better and last longer.
PRODUCT SPECIFICATIONS
Pressure Washer Specifications
Engine Specifications
PRESSURE
1800 DSi
FLOW RATE
2GPM
DETERGENT MIX
Use undiluted deteraent
WATER SUPPLY
TEMPERATURE
Not to Exceed 140°F
ENGINE MODEL
Briaas & Stratton
RATED HORSEPOWER
4.5
DISPLACEMENT
190CC
SPARK PLUG: Type:
Set Gap to:
Champion J-19LM
or equivalent
0.030 inch (0.76mm)
GASOLINE CAPACITY
1.6
U.S. Quart
OIL
SAE 30 weight
SOLID STATE IGNITION
AIR GAP
0.0125 inch
In the State of California a spark arrestor is required by
law (Section 4442 of the California Public Resources
Code). Other states may have similar laws. Federal laws
apply on federal lands.
Note: If you equip the engine of your pressure washer
with a spark arrestor muffler, the spark arrestor must be
maintained in effective working order by the owner/opera-
tor.
You can order a spark arrestor through your Sears
Service Center.
10