Craftsman 137.219100 - Manual (Page 20)

I
- ................. ■
____ J
iVIAiUmiMING YOUR DRILL PRESS
mmmm
For your own safety, turn the switch OFF and remove the
plug from the power source outlet before maintaining or
iubricating your drill press.
Frequently blow out using an air compressor or dust
vacuum, any dust that accumulates inside the motor.
A coat of automotive paste wax applied to the table and
column will help to keep the surfaces clean.
To avoid s.hock or fire hazard, if the power cord is worn
or cut in any way, have it replaced immediately.
LUBRICATION
.Ail of the drill press ball bearings are packed with grease
at the factory. They require no further lubrication.
Periodically lubricate the gear and rack, table eievation
mechanism of the spindle and the rack (teeih) of the quill.
20