Craftsman 137.219100 - Manual (Page 2)

SECTION
7
Warranty . - ... ...........................................................
Product Specifications ......................... ............................. ...................................... ....................“ ■ '
Accessories and Attachments .............. .o
Carton Contents
Know Your Drill
Glossary of Terms ‘ ‘
Assembly and Acljustmerits .............. -............. ...lu
Operation ............................................................................... .............................................................
Maintenance ... ........... ............. ............... .......................................................... -..................... ' ’ " ' '21
Troubiesliootiog guide
Paris........................ ------------------------------------------------------------------------------
Español
‘ ‘ "
WARRANTY
FULL ONE YEAR WARRANTY
If this product fails due to a defect in material or workmanship within one year from the date of purchase, Sears
will repair it free of charge.
Contact a Sears Service Center for repair.
If this product is used for commercial or rental purposes, this warranty applies only for 90 days from the date of
purchase.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Dept. 817 WA, Hoffman Estates, !L §0179 ________________ _________
CHUCK SIZE ......................1/2"
SPEEDS..................... .. .5 (540-3,600 RPM)
MOTOR.................... ...........120V, 60 HZ, 6 AMPS,
HORSEPOWER................. 1/2 HP (Max. Developed)
TABLE SIZE ....................... 8-1/4" X 7-1/4"
TABLE TILT........................ 45° RIGHT OR LEFT
SPINDLE TRAVEL ............. 2-3/8"
THROAT ............................ 5"
B.ASE SIZE . ...................... 14-3/8" x 8-1/4"
HEIGHT ..............................28-3/8"
PRODUCT SPECIFICATIONS
A WARNING
To avoid eieciricai hazards, fire hazards, or damage to
the tool, use proper circuit protection.
Your drill press is wired at the factory for 120V operation.
Connect to a 120V, 15 AMP branch circuit and use a
15 AMP time delay fuse or circuit breaker. To avoid shock
or fire, replace power cord immediately if it is worn, cut or
damaged in any way.