Craftsman 137.219100 - Manual (Page 10)

I
ASSEMBLY INSTRUCTIONS
ii WARNING
For your own safety, never connect plug to power source
outlet until all assembiy and adjustment steps are
completed, and you have read and understood the safety
and operating instructions.
TOOLS NEEDED
Slotted screwdriver
Combinatioii vi/rench
:zEi
8” S, 10" Adjustable wrenches
tj5)
-'FT
Framing square
Combination square ■
Socket wrench
with 23 mm. socket
A WARNING
The Driii Press is very heavy and MUST be lifted with the
help of 2 PEOPLE OR MORE, to safely assemble it.
COLUMN SUPPORT TO BASE (HG. A)
1. Position base (1) on floor.
2. Place column (2) on base, aligning holes in column
support with holes in base.
3. ■ Locate four long hex bolts (3) from loose parts bag.
4. Place a bolt in each hole through the column
support and the base. Tighten with an adjustable
wrench.
Fig. A
TABLE TO COLUMN ASSEMBLY (FIG. B THROUGH F)
1. Locale the worm gear, table crank, and table support
lock handle from the loose parts bag.
Insert the worm gear (1) into the table crank handle
hole (2) from inside the tabie support (3). Make sure
the woriTi gear {1) meshes with the inside gefr.
Insert the table support lock handle (4) into the hole
at the rear of the table support. Tighten.
NOTE: Table remo\/ed from support in illustration for
2
.
3.
4. Place the rack (5) in position inside the table support (3),
making sure the worm gear (1) on the inside of the
table support Is engaged with the teeth of the rack.
10 li