Tools required for assembly, To remove snow thrower from carton, Assembly – Craftsman 536.886260 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ASSEMBLY

Parts packed separately in carton (not shown full size)

2- Ignition Keys

(Attached to engine in plastic bag)

A WARNING: Always wear

safety glasses or eye shields

** wliile assembling snow

thrower.

TOOLS REQUIRED FOR

ASSEMBLY

1 - Knife to cut carton
1 - 1 / 2 inch wrenches

(or adjustable wrenches)

1 - 9/16 inch wrenches

(or adjustable wrenches)

1 - 3/4 inch wrenches

(or adjustable wrenches)

1 - Pliers (to spread cotter pin)
1 - Screwdriver

1 - Measuring tape or ruler
Figure 1 shows the snow thrower in the
shipping position.

Figure 2 shows the snow thrower com

pletely assembled.

References to the right or left hand side

of the snow thrower are from the view

point of the operator’s position behind
the unit.

Auger Drive Lever

Shifter

Lever

Traction

Drive Lever

Clutch Cable

Crank Assembly

Height
Adjust

Skid

Figure 2

TO REMOVE SNOW THROWER

FROM CARTON

1. Locate all parts packed separately

and remove from the carton.

NOTE:

Place fuel stabilizer in a safe

place until needed for storage.