Craftsman 139.535006 - Manual (Page 6)

Assembly
TO AVOID INSTALLATION DIFFICULTIES, DO NOT RUN THE GARAGE DOOR OPENER UNTIL YOU HAVE
COMPLETED STEPS, PAGE 15.
SXE P 1
Assemble Tee Rail & Attach Cable Pulley Bracket
TEE RAIL BACK
CTO CHASSIS)
CAUTION: Do not tighten the lock nuts until bolt
necks are seated in square holes.
Tee Rail
(End Seciiors)
Tee Rail
(Center Section)
1 /4" Lock Nut
Square Carriage
Bolt Hole
Cable pulley bracket
. attaches to FRONT
END of Tee Rail
; RAIL FRONT
(TO DOOR)
Align front end of tee rail with cable pulley bracket and
connect as shown. Tighten screws and nuts securely.
Carriage Bolt
1/4"-20x1/2"
Flange
PROCEDURE: Place the 3 Tee rail sections on a fiat
surface for assembly. THIS IS IM PORTANT. The center
section has two connection flanges The end sections
are identical.
Refer to illustration. BE SURE CENTER SECTION IS
POSITIONED ON THE CORRECT SIDE OF TEE
RAIL.
(When assembled, Tee rail has a front-to-back
position as shown).
Bolt center rail section to end sections with the hard­
ware illustrated.
SQUARE NECKS ON CARRIAGE BOLTS MUST BE
SEATED IN SQUARE HOLES IN TEE RAILS.
Cable Pulley
Bracket
Lock Washer
5/16"
Nut
5/16"