Craftsman 139.535006 - Manual (Page 15)

Installation
STEPS
Coimect Eiectric Power
CAUTION: BE SURE UNIT IS GROUNDED
ACCORDING TO LOCAL CODE
TO AVOID SERIOUS PERSONAL INJURY FROM ENTANGLEMENT, REMOVE ALL ROPES CONNECTEDTO THE
GARAGE DOOR BEFORE OPERATING DOOR OPENER.
REMOVE EXISTING GARAGE DOOR LOCKS OR USE A WOOD SCREW OR NAIL TO MAKE THEM INOPERATIVE,
INSTALLATION AND WIRING MUST BE IN COMPLIANCE WITH LOCAL BUILDING AND ELECTRICAL CODES.
OPERATION AT OTHER THAN 120V 60Hz WILL CAUSE OPENER MALFUNCTION AND DAMAGE,
IF LOCAL ELECTRICAL CODES DO NOT REQUIRE
PERMANENT WIRING: Insert the 3-prong plug into a
3-hole receptacle. UNIT MUST BE GROUNDED, DO
NOT USE A 2-WIRE ADAPTER,
IF LOCAL CODES REQUIRE PERMANENT WIRING:
Refer to illustration,,
PROCEDURE: Make connection through 7/8 inch
diameter hole in top of opener chassis,
1. Remove opener chassis cover by removing the 4
cover screws,
2. Remove attached 3-prong cord,
3. Connect black (line) wire to black wire on terminal
block; white (neutral) wire to white terminal wire; green
(ground) wire to green ground screw
STEPS
Install Lights and Lenses
PROCEDURE; Install a 75 watt maximum light bulb
in each socket as shown. The lights turn on automati­
cally when opener starts. After 4-1/2 minutes they
will turn off. Lights will REMAIN ON when Work Light
push button on Wall Control is pressed,
IMPORTANT NOTE: If the lights in your garage
door opener do not work, it may NOT be the fault of
the
opener. Some shorPneck bulbs, because of
their shape, do not make contact with the socket
base tab. Use standard-neck bulbs.
INSTALLING LENSES; Slide lenses into the lens
guides as shown. Snap bottom tabs into lens slots.
(The force and limit adjustment settings are located
on side panels behind lenses),
NOTE: FOR CONVENIENCE, LENSES MAYBE IN­
STALLED AFTER ADJUSTMENT, STEPS, PAGE20.
Lens
Slot
15