Using soaps/chemicals – Craftsman 919.678250 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(low To Use Your Pressure Washer
Dn the end of your spray gun is a nozzle that you can
wist from side to side. With the adjustable nozzle you
3an adjust the nozzle to either high pressure or low
jressure.
Turn the nozzle in a counter clockwise direction to
achieve low pressure. Turn nozzle clockwise for high
pressure.
For most effective cleaning, keep spray nozzle
between 8 and 24 inches of cleaning surface.
IMPORTANT: If you get spray nozzle too close,
especially on high pressure, you may damage the
cleaning surface.
• The pressure control knob is located on the pump.
You can increase the pressure by turning the knob
clockwise or decrease the pressure by turning the
knob counterclockwise.
NOTE: The maximum pressure for the unit is set at it’s
maximum setting at the factory. Do not attempt to adjust
the pressure higher than this factory setting.
Using Soaps/Chemicals
IMPORTANT: Use soaps and chemicals that are
designed specifically for use with pressure washers. To
apply soap/chemicals follow these steps:
Prepare the soap/chemical as required by your job.
Insert soap/chemical line into your container (soap/
chemicals not included).