Craftsman 919.678250 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Cut tie wrap off of high pressure hose. Unwind

high pressure hose to attach the threaded end to

the gun.

Connect chemical hose to the chemical injector
hose barb on pump.

CHEMICAL

INJECTOR

HOSE

PUMP

7. • Connect high pressure hose to the quick connect

outlet on pressure washer.

QUICK

CONNECT

NOTE: Always keep hose away from engine
muffler.

Your units pump is shipped with a
temporary plug that must be replaced with a

breather cap. This plug is located over the
pump’s oil port. Unscrew and remove this plug.
Remove the breather cap from the bag attached

to the plug and install it in the pump’s oii port.

BREATHEI

CAP

9. • Piace assembied gun and wand on pressure

handle bracket as shown.

CAUTION: Failure to replace the plug will result
in serious pump damage.

Checklist

Before going any further piease review the foiiowing:

• Be sure you have completed assembly instruction.

• Double check all fittings to be sure they are tight.

IMPORTANT: Before any attempt to start your pres
sure washer be sure to check engine oii (See Operation
under Engine Oii, page 9.)