Craftsman 919.678250 - Manual (Page 20)

• Squeeze trigger on pressure washer wand to relieve a
pressure caused by turning on the water. Water will
spew out of the gun in a thin stream. This will make it
easier to start the engine.
• Engage the safety latch on the spray gun. This locks
the trigger in place and keeps you from accidentally
spraying a high pressure stream.
On the engine there is a choke/run lever. Place lever
to the choke position.
• On the engine there is a throttle control lever. Place
throttle to the rabbit position. Always start engine
with throttle in the rabbit position. Place on/stop
switch to the “on” postion.
• Make sure fuel shut off valve is to the open position.
• Grasp the starter grip and pull slowly until resistance
is felt, then pull firmly to start engine.
• When engine starts, gradually move choke lever to
RUN position.
• If engine does not start after 5 pulls, place choke
back to run position.
• For hot engine starts make sure choke/run lever is in
the run position. Make sure fuel shut off valve is open
and throttle is in the run position.
NOTE: If any leaks are present shut unit down and
tighten fittings.
10