Cabletron Systems Expansion module 9T122-08 - Manual (Page 30)

9T122-08 Module Specific Information
28
Table 5 shows the various statistics after four screen refreshes:
Press the Space Bar to toggle to the desired value, then press the Return key.
FNB / TOKEN RING 1/TOKEN RING 2 (Toggle)
Allows you to select the interface for which statistics are displayed.
¥ If you select FNB, statistics for the FDDI interface are displayed.
¥ If you select TOKEN RING 1, statistics for the moduleÕs number one token ring
interface are displayed.
¥ If you select TOKEN RING 2, statistics for the moduleÕs number two token ring
interface are displayed.
¥ Press the Space Bar to toggle to the desired value, then press the Return key.
REFRESH (Toggle)
Allows you to select the interval at which the screen will be updated (the range is
3 - 99 seconds). To increase the number of seconds, press the Space Bar while the
cursor is on the command. To decrease the number of seconds, press the Back
Space
key while the cursor is on the command.
CLEAR
A command that only appears when you select ACCUMULATE as a statistic
reporting method. The CLEAR command allows you to manually reset the
screenÕs statistics to zero and then start to accumulate statistics from that point in
time. For example, you may have accumulated statistics for 45 minutes, but now
you want to see accumulated statistics for the current period. In this case, you
would position the cursor onto the CLEAR command and press the Space Bar.
The screenÕs statistics will reset to zero and start to accumulate again.
RETURN
Allows you to exit the 9T122-08 Bridge Statistics Screen.
Table 5. Statistics After Four Refreshes
After 1st
Screen Refresh
After 2nd
Screen Refresh
After 3rd
Screen Refresh
After 4th
Screen Refresh
TOTAL 1623 1636 1685 1712
ACC 0 13 62 99
DELTA 0 13 49 27