Cabletron Systems Expansion module 9T122-08 - Manual (Page 22)

9T122-08 Module Specific Information
20
Exiting the Token Ring Port Configuration Screen
To exit the Token Ring Port ConÞguration Screen, use the arrow keys to highlight
RETURN
, then press the Return key.
Table 4. Token Ring Port Operational Codes
If the port is a...
And if the port is
administratively
turned...
Then, the operational status is:
Ring Port
RI (ring-in) or
RO (ring-out)
ON
ACT (Active)
The port is on and is passing data to the ring.
WRP (Wrapped)
The port is on, but it is autowrapped, either because of a
cable failure or because the cable is not connected.
OFF DIS (Disabled)
The port is off (wrapped by Management).
Lobe Port
ON
INS (Inserted - phantom link is detected)
The lobe port is inserted into the ring.
ENB (Enabled - no phantom link is present)
The lobe port is not inserted into the ring.
OFF
LNK (Linked - phantom link is detected)
The lobe port is trying to gain access to the ring, but it has
been prevented.
BYP (Bypassed -no phantom link is present)
The lobe port is not attempting to gain access to the ring.
ON or OFF
FLT (Speed Fault)
The ring speed of the port is in conßict with the ring speed
of the designated token ring. The port will remain
wrapped.