Setting the clock, Playing a disc, Setting the alarm time – Sony ICF-CD825RM User Manual
Page 6: Notes, To ooze for a few more minutes, To use both sleep timer and alarm, Setting the alarm, Setting the alarm mode, Playing the radio
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting the Clock
S<'t tho tinu' whon tho CO or radio is turnrxi ott.
1
ring in the unit.
The dispKiv u'ill flash "AM 12.(X1".
2
While holding down
TRACK/CLOCK,
press either
TIME SET/TRACK
+ or -
until the correct time appears in the
display.
When you release
TRACK/CLOCK,
the
clock begins to operate and
flashes.
• To set the current time rapidly, keep pressing
the + or - button while holding down TRACK/
CLOCK.
• To set the current time from zero seconds, at
step 2, release TRACK/CLOCK with the time
signal.
Playing a Disc
An 8 cm (3-inch) CD can be played without an
adaptor.
1
Lift
UFT OPEN
to open the CD
compartment lid and place a disc.
Lift.
Label surface up.
Close the lid.
b\ Us
To si't tho
tSBuzziff, abrm
not tovwh the
svirtacc.
IX> not stick pa^x'r or
tape
nor write
anything on the
surface.
2
Press CD
Wl
and the display lights
"01". The current number (01 to 99)
appears in the display window. After
10 seconds^ the indication becomes the
current time, but the "CD ► "
indication remains.
3 Adjust VOLUME.
Locating a Particular
Portion
Locating a particular saiection (AMS*)
To locate the beginning of the current selection,
press
To locate the next selection, press
PW.
Locating a particular point in a selection
(SEARCH)
To go back at high speed, keep press«3.
To go ahead at high speed, keep
PW
pressed.
• AMS is
abbreviation of Automatic Music
Sensor.
• If you press repeatedly, the player locates
the previous selections, if you press
- repeatedly, the player locates the next
selections and stops at the last selection.
• To slop play, press OFF/ALARM RESET.
• To pause, press
CD
Ml and the "CD "
indication flashes. To resume play, press
CD Wl
again.
• To change the dock mode to track mode, press
TRACK/CLOCK.
Press
TRACK/CLOCK
again, and the current
tin>e appears.
• To
eject
a disc,
lift LIFT OPEN.
• To handle compact discs
This way
^
Notes
• Do not open the CD compartment lid while
playing, otherwise, the disc will be damaged.
Be sure to stop the disc first.
• When you press CD ►!!, if there is no disc in
the CD compartment, the “00" indication
flashes for 10 seconds and the unit will be
turned off.
• If the Cp] alarm is activated while
listening to the CD, the track changes to that
preset by prising WAKE UP TRACK.
Playing the Radio
1
Press RADIO/SLEEP to turn on the
radio.
The "RADIO" indication will appear
ai\d the "On" indication will appear in
the display. After 10 seconds, the
indication becomes the current time but
the "RADIO" indication remains.
2
Adjust VOLUME.
3
Select the BAND.
4
Tune in a station using the TUNING
dial,
• To turn off the radio, press OFF/ALARM
RESET.
• To improve
radio
reception
FM; Extend ttie FM wire antenna to improve
FM reception.
- AM: Rotate the unit horizontally for optimum
reception. A ferrite bar antenna is built
into the unit.
Setting the Alarm
You can set the CD,
radio
and buzzer alarms at
the preset time. Before setting the alarm, be sure
to set the clock. (See "Setting the Clock".)
Setting the Alarm Time
To set the
CD I alarm
1 While holding down
ALARM A,
press
either
TIME SET/TRACK
+ or - until the ’
desired time appears in the display
window.
The
" CP I "
indication'flashes and
lights.
2
Release ALARM A. The alarm time is
set and the indication becomes the
current time.
3
While holding down WAKE UP TRACK,
set the desired track by pressing or
►W beside TIME SET/TRACK.
4
Release
WAKE UP TRACK.
The track is
preset and the indication becomes the
current time.
Note
When the CD player is preset to start with track
5, it will always start with track 5 even though
you change the CD, unless you change
WAKE
UP TRACK
1
While holding down
ALARM B.
press
either
TIME SET/TRACK
+ isr - until the
desired time appears in tho dispbv
window. The ' KlRAPto] " and
" I^BUZZfBl " indication flash and ': '
lights.
2
Release ALARM B. The alarm time is
set and the indication becomes the
current time.
Setting the Alarm Mode
Before setting the alarm mode, be sun? to
Time’.)
1
Press ALARM MODE until the aUrm
you want appears in the display
window.
Each time you press ALARM MODE.,
the alarm indication changes
as folknvs.
No alarm _________
indication 13 CP
I__H CD
I
and
• To stop the alarm, press OFF/ALARM RESET,
The alarm will sound at Úie same time the next
day.
• To cancel the alarm, while holding «km-n
ALARM MODE, press OFF/ALARM RESET^
• To check the alarm time you set press ALARM
A or ALARM 8.
Notes
• The alarm does not function, unless setfee
clock and B COl / I^MDIOl / ^fitgZERl
alarm.
• If you set the CD alarm and radio or buzzer
alarm at the same time, CD alarm sounds.
• When you set the CD alann, if there is no dix
in the CD player, ñ\e buzzer will sound at the
time you set.
• The selected alarm is activated at the time you
set, and automatically turns off after tiO
minutes.
• Whet\ the CD alarm comes on, ti>e “
indication flashes.
If you want to stop flashing, press Q> ML The
CD player will stop flaying at the last track.
• When tt\e radio alarm is activated, the
" i^^ÄD/o1" indication flashes. If you wraiir
to keep on listening to radio and stop flashanfe
press RADIO/SLEEP. The ' ^fMOOl'
indication remains.
• The buzzer sound level is fixed, and
independent of VOLUME.
To Ooze for a Few More Minutes
1
Press
SNOOZE/SLEEP OFF
The CD,
radio or buzzer will shut off but will he
activated automatically after about 8
minutes. You can repeat this process as
many times as necessary.
• While SNOOZE/SLEEP OFF function ts
operating, the alarm indicabon flashes.
To Use Both Sleep Timer and Alarm
You can fail asleep to the radio and vou will be
awakened by the CD, radio or buzzer alarm at
the preset time.
1
Set the alarm. (See "Setting the
Alarm".)
2
Set the sleep timer. (See "Setting the
Sleep Timer".)