Sony STR-D790 - Manual (Page 23)

Recording an Audio Source
Recording onto an Audio Tape Deck or DAT Deck Tape Dubbing
Audio signals
1
Select the desired program source with the
function selector. |
For an FM/AM broadcast, tune in the desired station.
2
Set the tape (DAT) deck in the recording mode.
3 Start playback of the selected program source.
Note on recording
For TAPE 1,2 and DAT REC OUT jacks, the settings of
SOUND FIELD and DBFS do not hpve any effect on
recording.
Monitoring the recorded sound
If you have connected a 3-head tape deck to the TAPE 2
jacks, you can monitor the recording results. While
recording or dubbing, press TAPE 2 MONITOR so that the
TAPE 2 MONITOR indicator lights yp. To listen to the
source sound again, press the button again so that the
indicator goes off.
Audio signals
1,4
1 Insert the recorded tape into tape deck 1 (or the
OAT deck).
2
Insert a blank tape into tape deck 2 and adjust the
recording level.
3
Press TAPE 1 or DAT to select the deck for
playback.
4
Start the playback of the tape (or the DAT) in tape
deck 1 (or the DAT deck), and set tape deck 2 in
the recording mode.
Dubbing will start.
Note on tape dubbing
Tape dubbing is possible only in the following directions:
From
(Playback deck)
To
(Recording deck)
Tape deck
connected to
TAPE 11N Tape deck connected to TAPE 2 OUT
DAT deck connected to DAT OUT
DAT deck
connected to
DAT IN
Tape deck connected to TAPE 1 or 2
OUT
Press the function selector according to the playback deck.
23