Sony SLV-M20HF User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

step 2: Setting up the remote commander (continued)

Q (3Û

‘O ■© ■© CD CD

■© ■© ■©

'CD

Setting the COMMAND MODE switch

To remotely control the VCR with

the remote commander, set
COMMAND MODE on the
remote cornmander to the same
position as that on the VCR.
Usually set to VTR 3. Change the

position as shown below to
control other Sony VCRs:

VTR 1:

For Sony Betamax format VCRs

VTR 2:

For Sony 8mm format VCRs

VTR 3:

For Sony VHS format VCRs

To change the command mode
position of the VCR, press and
hold COMMAND MODE on the

VCR for about two seconds and

repeat until the desired position
appears in the display window.

COMMAND
MODE

COMMAND MODE

Controlling other TVs with the remote commander

The remote commander is preprogrammed to control non-Sony TVs. If your TV
is listed in the table below, set the appropriate manufacturer's code number.

Set I TV I/ |VIDEO|at the top of the remote commander to |TV|.

Hold POWER down, and enter your TV's code number(s) using the
number buttons. Then release POWER.

Now you can use the POWER, VOL + / - , CH + / - , and TV/VIDEO buttons to
control your TV. You can also use the buttons marked with a dot (•) to
control a Sony TV. To control the VCR, reset |TV| /1 VIDEO| to |VIE)EO|.

Tip

• If you set your TV's code number correctly while the TV is turned on, the TV turns

off automatically.