Sony SLV-M20HF - Manual (Page 10)

step 3: Hookups (continued)
B Use this hookup if your TV has the S-Link^'^ function
VCR stereo receiver
Note
To play a tape in stereo, must use the A/V connection.
AIM hookup: VCR setup
After you've connected your TV and completed antenna or cable hookup,
u^e the following procedure to set up the VCR.
Set AUTO ANT SEL to OFF and
press the cursor stick (OK). Press MENU and select
ADVANCED OPTIONS.
rarggiii
TIMER SET/CHECK
TUNER PRESET
CLOCK SET
LANGUAGE
CABLE BOX CONTROL
ADVANCED OPTIONS
SMARTFILE EDIT
Use M to se I ec
item, then push |
AUTO STEREO
AUDIO MIX
TUNER AUDIO
SHARPNESS
DEFAULT SPEED
Use [TT] to select
item,then push
ON OFF
ON OFF
ON OFF
MAIN SAP
riT - H
EP
For details, refer to page 34 of the
supplied operating instructions.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.