Sony CDP-361 - Manual (Page 12)

Additional Information
Notes on CDs
On handling CDs
• To keep the disc clean, handle the disc by its edge. Do not
touch the surface.
• Do not stick paper or tape on the disc.
Not this way
• Do not expose the disc to direct sunlight or heat sources
such as hot air ducts, nor leave it in a car parked in direct
sunlight as there can be considerable rise in temperature
inside the car.
• Do not use any commercially available stabilizer. If you do,
the disc and the player may be damaged.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a cleaning cloth. Wipe
the disc from the center out.
Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for vinyl LPs.
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
■♦Check that the player is connected securely.
“♦Make sure you operate the amplifier correctly.
^ Adjust the playback level using the PHONE LEVEL
control while listening with headphones.
"♦Adjust the output level with LINE OUT LEVEL on the
remote (CDP-361 only).
The CD does not play.
^There's no CD inside the player ("no dISC" appears).
Insert a CD.
^Place the CD with the label side up on the disc tray
correctly.
“♦Clean the CD (see above).
^Moisture has condensed Inside the player. Remove
the disc and leave the player turned on for about an
hour (see page 2).
The recording level has changed. (CDP-361 only)
^The recording level changes if you adjust the output
level with LINE OUT LEVEL on the remote during
recording.
The remote does not function. (CDP-361 only)
^Remove the obstacles in the path of the remote and
the player.
^ Point the remote at the remote sensor @ on the player.
■♦Replace all the batteries in the remote with new ones
if they are weak.
Specifications
Compact disc player
Laser
Wavelength
Frequency response
Signal-to-noise ratio
Dynamic range
Harmonic distortion
Channel separation
Outputs
Semiconductor laser
780 - 790 nm
2 Hz to 20 kHz ± 0.5 dB
More than 100 dB
More than 98 dB
Less than 0.0045%
More than 95 dB
Jack
type
Maximum
output
level
Load
impedance
LINE OUT
(VARIABLE)
(CDP-361) Phono
jacks
2 V
(at 50 kiîohms) Over 10 kiiohms
LINE OUT
(CDP-261) Phono
jacks
2 V
(at 50 kilohms) Over 10 kilohms
DIGITAL
OUT
(OPTICAL)
(CDP-361) Optical
output
connector -18 dBm Wave length: 660 nm
PHONES Stereo
phone
jack
10 mW 32 ohms
General
Power requirements
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
Supplied accessories
120 V AC, 60 Hz
low
430 X 100 X 295 mm
(17 X 4 X 11 5/8 in.) ind. projecting
parts
3.2 kg (7 lbs 1 oz)
Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (CDP-361 only) (1)
Sony SUM-3 (NS) batteries (CDP-361 only) (2)
Design and specifications are subject to change without notice.
Sony Corporation Printed in China