Sony CDP-361 - Manual (Page 10)

Recording From CDs
'Q' When tracks, which aren't numerically consecutive on
the disc,^re programmed consecutively (i.e. 1, 3, 5
etc.)
A one-st'cond access time blank is added between the
tracks.
Recording a CD by Specifying
Tape Length (Time Edit)
You can have the player create a program that will fit
the length of the tape.
The player automatically creates a program, keeping
the original order of the disc.
The program can contain up to 24 tracks (a pause
inserted between tracks is counted as one track).
Note that tracks whose numbers are over 24 cannot be
programmed.
O IK)C>ll EDIT/TIME FADE
Press EDIT/TIME FADE before you start playing
until EDIT appears and "A" in the f'^1 indication
flashes in the display.
5 Start recording on the deck and then press O on
the player.
When you record on both sides of the tape, the
player pauses at the end of the program for side A.
6
When you record on side B, reverse the tape and
press O or II on the player to resume playing.
To cancel time edit
Press CONTINUE.
'Q' You can program the tracks you want in advance
Select the tracks before doing the above procedure. The
player creates a program from the remaining tracks. In
this case, you cannot select "HALF" to specify the tape
length.
'Q' You can freely specify the tape length
Set the tape length using number buttons. To enter "0,"
use button 10.
Example: When the tape length of one side is 30 minutes
and 15 seconds
. Press 3, 10, 1 and 5.
'Q' When tracks, which aren't numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
Press IKKl-4^ or ►►t’W to specify the tape
length.
Each time you press these buttons, the display
changes as shown below, with the tape length of
one side following each indication.
> H A L F -*C-46>-
(23.00)
.C-54»
(27.00)
-.C-60»-
(30.00)
.C-74.^
(37.00)
• C-90».
(45.00)
When you select "HALF"
The player sets the program of each side to a half of the
total playing time of the disc. Note that you cannot select
"HALF" when the disc has more than 24 tracks.
Press EDIT/TIME FADE to have the player create
the program.
The display shows the tracks to be recorded. "B" in
the r°^1 indication flashes in the display.
When you record on both sides of the tape, press
EDIT/TIME FADE again.
The player inserts a pause, then creates the
program for side B. The display shows the
programmed tracks.
When you record on one side of the tape or on a
DAT or MD, skip this step.
Fading In or Out
You can manually fade in or out to prevent tracks from
starting or ending abruptly.
Note that you cannot use this effect when you use the
DIGITAL OUT (OPTICAL) connector (CDP-361 only).
EDIT/TIME FADE FADER
IKKI-4^/^»t>B
To Press FADER
Start play fading in During pause. The -•flashes and play fades in.
End play fading out When you want to start fading out.
The indication flashes. The play
fades out and the player pauses.
10