Sony SPP-AQ500 - Manual (Page 38)

Troubleshooting (continued)
Symptom Remedy
The handset doesn’t ring. • Set the RING ON/BATT SAVE switch on the
handset to RING ON.
• The battery may be weak. Charge the battery for
"s
more than 12 hours (page 12).
• Make sure you set up the ba.se unit correctly (page
c
>
9).
*5 • Move the handset closer to the base unit.
0)
C£
• While you’re storing a speed dialing number, you
can’t receive any calls.
• Replace the handset to the base unit for a while to
recharge the battery pack.
You hear five short beeps • Make sure you follow the procedure in storing the
U)
and can't store a speed number correctly (page 18).
c dialing number. • Make sure the number (including the tone and pause
2
* digits) is fewer than 16 digits.
“D You hear fi\ e short beeps • You entered a dialing key to which no phone
o; when \ou try to make a number has been stored.
LTJ speed dialing call.
Speed dialing is incorrect. • Store a correct number (page 18).
The handset doesn't ring • The handset may be engaged in conversation.
when calling from the base • Set the RING ON/BATT SAVE switch to RING
unii. ON.
• The battery may have little or no power. Charge the
c battery for more than 12 hours (page 12).
<0
Q l
• Raise the antenna of the base unit vertically and
fully extended.
• Place the base unit away from noise sources (page
8)
• Move the handset closer to the base unit.
38™ Additional Information