Resetting the digital security code – Sony SPP-AQ500 User Manual
Page 35
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Resetting the digital security
code
Since a random security code is automatically assigned between the
base unit and the handset when you charge the battery pack for the
first time, you normally do not need to reset the security code.
However, in the unlikely event that you suspect that another cordless
phone uses the same security code, you can manually change the
code as follows:
1
Replace the handset on the base unit.
2
Press ( PAGE ).
3
Lift the handset for more than one
second. Then replace the handset on the
base unit and keep it for more than
three seconds to complete the code
change.
Notes
•
.Make sure that the RING ON/BATT SAVE switch is
set to RING ON.
•
If the battery pack in the handset is completely
discharged, or is removed from the handset I'or more
than several seconds, the digital security code stored
w ill be lost. If this happens, charge the battery pack,
and a new security code will be automatically
assigned.
Tip
This procedure will change the code in boih the base
unit and the handsel. The code can be changed as often
as desired.
>
a
a
?+
o'
3
S L
3
o
-s
3
o
(-*■
o'
3
Additional Information 35™